Post Board

SLS = Selective Laser Sintering Posted on 28 Jan 21:26

Printing via SLS is more expensive per kendama than buying plastic filament and a personal-sized 3D printer, but the added value in performance and appearance speaks for itself.

Prototype: Precursor to Project Vii Posted on 11 Jan 16:14

These kens almost didn't happen. If not for the guidance of professors, peers and visiting designers, these concepts would not have made it into the project scope in time for the show ...

Prototype: MK1 Kendama Helmet Carrier Posted on 31 Dec 14:14

The Kendama MK1 Helmet Carriers was the result of a two week think-it-and-make-it Industrial Design course project at the UW ...