Post Board

Tora Tama Process Posted on 06 Mar 21:59

You need some pretty sharp angles. Sharp 15ยบ angles. So sharp you could cut yourself just looking at them carelessly! Maybe not that sharp.

Orbiter Tama Process Posted on 18 Dec 18:58

2016 is nearly done, but I had time to push through one last project before 2017 arrives. A little talk about what went into the Orbiter tama design.

12X Tama - Padauk/Yellow Posted on 20 May 22:25

Sunlight streaming through the windows, spicy exotic wood dust filling the air and the blare of a great playlist accompanying the buzz, clack and chatter in the workshop.

Crafted: 12-Crossed Lamination Tama Posted on 09 Jan 21:25

Since we already know what a 90 degree stack will get us, we opted to do our cuts and laminations at 45 degrees from the center axis ...

Crafted: The Hidden Stringway Posted on 03 Jan 23:22

The goal of Project Vii is to reach beyond the normal and bring into reality something new, fun, and exciting. With this project we look to innovate on and challenge accepted ideas of what currently is ...